Earlex HG2000 Betriebsanleitung PDF herunterladen (Seite 9)

ATTENTION! Before performing any work on the equipment, disconnect

from the power supply.

9.1. MAINTENANCE

Your Power Tool has been designed to operate over a long period of time with a minimum of

maintenance. Continuous satisfactory operation depends upon proper tool care and regular

cleaning.

9.2. LUBRICATION

Your power tool requires no additional lubrication.

9.3. CLEANING

Keep the ventilation slots clean and free from dust and dirt to prevent overheating of the

engine.

Regularly clean the gun housing with a soft cloth, preferably after each use.

If the dirt does not come off, use a soft cloth moistened with soapy water.

Never use solvents such as petrol, alcohol, ammonia water, etc. These

solvents may damage the plastic parts.

10. TECHNICAL DATA

Power Supply 220-240V 50-60Hz

Max Output 2000W

Air temperature / Flow

1) 50˚C; 250L/min

2) 50-600˚C； 300L/min

3) 50-600˚C; 500L/min

11. TROUBLESHOOTING

If a problem occurs always switch off the unit immediately at the mains.

Heat gun does not turn on Check fuse is sound and is BS1362 13 Amp rated.

If necessary, replace with a BS1362 13 Amp fuse.

8.4. STATIONARY USE

 This tool can also be used in stationary mode.

 Place the tool onto the workbench.

 Secure the cable to prevent pulling the tool off the workbench.

 Carefully switch the tool on.

8.5. COOLING DOWN

The nozzle and accessory become very hot during use. Let these cool down before

attempting to move or store the tool.

 To reduce cooling time, switch the tool to position 1 which is at the lowest air temperature

and adjust the air flow to MAX. and let it run for a few minutes.

 Switch the tool off and let it cool down for at least 30 minutes.

9. MAINTENANCE AND CLEANING

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Earlex HG2000 Betriebsanleitung Seite 9