Earlex SPRAY STATION Bedienerhandbuch PDF herunterladen (Seite 6)

Type of paint Cleaning

Water based paint Clean with water

Oiled based paint Clean with appropriate thinner e.g. White Spirit

CLEANING INSTRUCTIONS

PRAY GUN

HINT: Before removing or re-inserting the Needle and Fluid Tip ensure the Spray Gun has been flushed through with water or the appropriate

thinner so the inner tube is clean.

HINT: When done immediately the cleaning operation can take you less than 5 minutes. If taking a break, leave the Spray Gun in a plastic bag to

prevent the paint from drying.

• Remove the Paint Container (12).

• Pour any leftover paint into its container so that it can be used for the future. Pull the Trigger to allow paint to run out of the Pick-up Tube (11).

• Pour a quantity of the respective thinner into container, shake the Spray Gun lightly, reassemble the Spray Gun, then spray this liquid though the

Spray Gun. Repeat this until the thinner being sprayed is coming through with no traces of paint.

• Clean any traces of paint off the outside of the Spray Gun.

• Clean the Paint Container Seal (10).

LUID TIP AND NEEDLE

• Unscrew Air Cap Ring (2).

• Remove the Air Cap (3).

• Remove the Spray Direction Plate (4).

• It is recommended that you push the Trigger forward to help release the Fluid Tip (5).

• Using the Needle and Fluid Tip Tool - pincer end A (1) remove the Fluid Tip (5).

• Insert the Needle and Fluid Tip end B (1) into the inner tube and unscrew the Needle anticlockwise, then pull to release the Needle.

• Place all of these items into a container and clean, then using a brush and the respective thinners.

• Clean the inside of the body of the Spray Gun.

• Thoroughly dry all parts before reassembling.

• Reassemble parts in reverse order.

• Ensure the Air Cap Ring (2) is fully tightened and the Fluid Tip is pushed into place so that the Spray Gun Needle will shut off. NB: Ensure the

Spray Direction Plate is free to move. If necessary loosen the Air Cap Ring (2) slightly.

• NEVER DISPOSE OF PAINTS OR SOLVENTS DOWN THE DRAIN. ALWAYS USE YOUR LOCAL WASTE COLLECTION SITE.

• The motor unit itself does not require any specific maintenance apart from checking that the filter is not clogged up (the filter can be removed and

washed). The filter can be found in the base of the motor unit.

Important: Each Fluid Needle is manufactured to fit the size of the corresponding Fluid Tip. Do not try to fit a 2.0 mm Fluid Needle to a 3.0 mm

Fluid Tip.

CAUSE ACTION REQUIRED

Paint too diluted Add undiluted paint

Paint output too high Reduce the paint output by adjusting the Paint Flow Adjuster (9)

Moving too slowly Increase speed of application

Spray Trigger held for too long Release Trigger sooner

Spray Gun too close Increase the distance between the Spray Gun and the work

surface

Paint too diluted Add undiluted paint

Paint output too low Increase the paint output by adjusting the Paint Flow Adjuster (9)

Moving too fast Reduce speed of application

Spray Gun clogged Clean the Spray Gun

Spray Gun too far away

Move the Spray Gun closer to the work surface

Paint too thick Add thinner

Fluid Tip clogged Clean the Fluid Tip (5)

Pick-up Tube clogged Clean Pick-up Tube (11)

Air Hose split Replace air Hose (13)

Grainy paint Filter the paint

Paint Container almost empty Refill Paint Container (12)

Spray Gun at an angle Check that the Pick-up Tube (11) is pointing towards the paint

Air inlet blocked Check the condition of the Filter (14) and clean if necessary

You move your wrist Move your fore arm instead

Either too much or not enough paint Use the Paint Flow Adjuster (9) to control the flow

PROBLEM

The paint drips onto item being

painted

Paint is too thin or irregular

No paint being released

Too much paint in an area

Application

TROUBLESHOOTING

SPRAY GUN

hv2900 06-09 A4:Layout 1 18/8/09 14:23 Page 6

1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare

Earlex SPRAY STATION Bedienerhandbuch Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spritzpistole Earlex SPRAY STATION